Cisco Systems PGW 2200 Switch User Manual


 
A-31
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Appendix A XECfgParm.dat File Parameters
Understanding the XECfgParm.dat File Format
engine.SysSGCPREtryTimerInterval The interval between SGCP message transmissions, in
milliseconds.
Default: 1000
Note Do not change this value.
engine.SysTraceLevel A debugging tool that allows for different levels of engine
tracing.
Default: 3
Note Do not change this value.
engine.SysVirtualSwitch Indicates whether the Cisco PGW 2200 Softswitch host
functions as a signaling controller or a virtual switch
controller.
Values:
0—Signaling controller (nailed trunks, no auditing is
initiated)
1—Virtual switch controller (switched trunks)
Default: 0
Note During the startup of the
Cisco PGW 2200 Softswitch software, this
parameter is be set automatically to tune the system
for optimal performance.
Note For Release 9.4(1) and later, the values of the
parameters listed below are automatically set based
on the Cisco MGC type you select, to maximize
performance for that configuration. Any attempt to
change the values of these parameters is overwritten.
engine.SysMdlMemoryReduction
engine.CALL_MEM_BLOCK_SIZE
engine.CALL_MEM_CHUNK_SIZE
*.CPUTimerInterval
*.numberOfThreads
engine.VersionTimeoutValue Defines the timeout interval in number of milliseconds for
version messages sent to the media gateway. This delay
determines how long the Cisco PGW 2200 Softswitch waits
for a response from the media gateway during the exchange
of features prior to the audit.
Value: Any integer.
Default: 10000
Table A-1 Cisco PGW 2200 Softswitch 9.x XECfgParm.dat File Configuration Parameters
Configuration Parameter Definition