Cisco Systems PGW 2200 Switch User Manual


 
4-21
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 4 Configuring the Cisco PGW 2200 Softswitch Software
Configuring SNMP Support Resources
=================== Add Trap Menu ===================
1. TargetAddress: 6.6.6.6:0 , TargetAddrParams: v1ExampleParams , IP Mask:
255.255.255.255:0
Would you like to proceed with the Add [n]/[y]?
Step 2 Enter y to add a Trap Destination (if you enter n to cancel the addition, you return to the SNMPD
Configuration Main Menu).
Text similar to the following is displayed:
Enter IP Address (x.x.x.x):
Step 3 Enter the IP address listed in Step 1:
7.7.7.7
Text similar to the following is displayed:
Enter Trap Type (v1 or v2c):
Step 4 Enter the Trap Type based on your SNMP manager. The following entry is an example:
v1
Text similar to the following is displayed:
'snmpTargetAddrEntry 483 snmpUDPDomain 7.7.7.7:0 100 3 TrapSink v1ExampleParams
nonVolatile 255.255.255.255:0 2048
' is about to be added. Are you sure that you want to add this Trap Entry [n]/[y]?
Step 5 Enter y to add a Trap Destination (if you enter n to cancel the addition, you return to the SNMPD
Configuration Main Menu).
Text confirming the addition of the Trap Destination is displayed, followed by the SNMPD
Configuration Main Menu:
Adding Trap: snmpTargetAddrEntry 483 snmpUDPDomain 7.7.7.7:0 100 3 TrapSink
v1ExampleParams nonVolatile 255.255.255.255:0 2048
=================== SNMPD Configuration Main Menu ===================
1. View Configuration Entries
2. Add an SNMP Community
3. Delete an SNMP Community
4. Add a Trap Destination
5. Delete a Trap Destination
6. Activate the New Settings
Enter a selection (1 through 6) or 'q' to quit:
ENTER YOUR SELECTION.
Step 6 Enter your selection. For detailed procedures for your selection, go to the section listed below:
Adding an SNMP Community Entry, page 4-17
Deleting an SNMP COMMUNITY, page 4-19
Adding a Trap Destination, page 4-20
Deleting a Trap Destination, page 4-22
Activating the New Settings, page 4-23