Filter
Top Products
A-19
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Appendix A XECfgParm.dat File Parameters
Understanding the XECfgParm.dat File Format
*.tablesFile Location of the database directories.
Default: ../etc/tables.dat
Note Do not change this value.
*.tempDir Location of the temporary files.
Default: /tmp
Note Do not change this value.
*.tibcoSupport Determines whether or not the system supports a TIBCO
maintenance interface.
Default: disable
Valid values: enable or disable
*.transpathId Identifies the local Cisco PGW 2200 Softswitch host in a
redundant configuration. The IDs must be unique in an
active and standby pair.
Value: Any integer up to 2 digits.
Default (for the active host): 01
Note If you have two Cisco PGW 2200 Softswitch hosts
in a failover configuration, the number for each host
must be different in the XECfgParm.dat file.
*.Virtual_IP_Addr1 Specifies a virtual IP address for a LAN interface. This IP
address must be within the subset of the IP address defined
for *.IP_Addr1.
Default: 0.0.0.0
Valid values: An IP address expressed in dotted decimal
notation.
*.Virtual_IP_Addr2 Specifies a virtual IP address for a LAN interface. This IP
address must be within the subset of the IP address defined
for *.IP_Addr2.
Default: 0.0.0.0
Valid values: An IP address expressed in dotted decimal
notation.
Table A-1 Cisco PGW 2200 Softswitch 9.x XECfgParm.dat File Configuration Parameters
Configuration Parameter Definition