Filter
Top Products
A-39
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Appendix A XECfgParm.dat File Parameters
Understanding the XECfgParm.dat File Format
pom.dataSync Indicates that the Provisioning Object Manager (POM)
should synchronize the provisioning data at startup.
Values:
• true—POM is enabled, data is synchronized.
• false—POM is disabled, no data synchronization
(default).
Note If you have two Cisco PGW 2200 Softswitch hosts
in a failover configuration, set this value to true. If
you have a standalone Cisco PGW 2200 Softswitch,
set this value to false.
Note When the initial Cisco PGW 2200 Softswitch
configuration on the active host is deployed, you
must change the pom.dataSync parameter to true in
the XECfgParm.dat file on the standby host. After
setting this parameter to true, you can start the
Cisco PGW 2200 Softswitch software on the
standby host. As the Cisco PGW 2200 Softswitch
software comes up, the data on the standby host is
synchronized with the data on the active host and the
active host goes into the standby state.
To accommodate failover conditions where the
current active host can become the standby host, you
must also set the pom.dataSync parameter to true on
the current active host.
Note If you are trying to maintain calls during an upgrade
of a redundant system and you want to preserve your
configuration, verify that the pom.dataSync
parameter is set to false in
/opt/CiscoMGC/etc/XECfgParm.dat.
pom.port Indicates the port number the POM uses to communicate
with its peer in a fault-tolerant configuration.
Value: Any integer from 4001 to 4050
Default: 4001 or default
Note This is a platform-specific value and depends on
your system installation. You should only modify
this value if the default port (4001) is being used by
another process or application.
procM.almDwellInterval Seconds that the process manager must wait before clearing
an alarm.
Default: 15 seconds
Note Do not change this value.
Table A-1 Cisco PGW 2200 Softswitch 9.x XECfgParm.dat File Configuration Parameters
Configuration Parameter Definition