Filter
Top Products
4-9
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 4 Configuring the Cisco PGW 2200 Softswitch Software
Initial Cisco PGW 2200 Softswitch Software Configuration
A dialog box displays, warning that the MGC Environment Configuration Tool is for initial system
configuration only.
Note To run the MGC Environment Configuration Tool in detail mode, enter the command MGC_Setup
-detail.
Step 2 Click Yes to continue running the XECfg program.
The MGC Environment Configuration Tool screen expands to provide information from the
XECfgParm.dat file. Figure 4-1 shows the MGC Environment Configuration Tool screen.
Figure 4-1 MGC Environment Configuration Tool
Table 4-5 explains the startup parameters listed in the MGC Environment Configuration Tool.
Table 4-5 MGC Environment Configuration Tool Startup Parameters
Field Usage
MGC Type Indicates whether the Cisco PGW 2200 Softswitch connection type.
SWITCHED-MGC specifies a dynamic connection such as a trunk group;
NAILED-UP specifies a permanent connection such as a sigpath.
Operational Mode Indicates the whether the Cisco PGW 2200 Softswitch is operating as a
stand-alone system or in a fault-tolerant configuration with an active and
standby Cisco PGW 2200 Softswitch.
Note If you select Active/Standby, you must provide a peer IP address.