Filter
Top Products
D-26
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Appendix D Sample Installation Scripts
Sample Configured XECfgParm.dat Files for Cisco PGW 2200 Softswitch Release 9.8(1)
engine.RelINAPCallsAfterSwOver = true
#----------------------------------
# Disk Monitor Parameters
#----------------------------------
diskmonitor.Limit = 7 # Minimum number of days to preserve (Trimming only
occurs when threshold is exceeded. )
diskmonitor.Threshold = 80 # percentage full threshold
diskmonitor.SoftLimit = false # set to true to allow override of preserve limit,
setting it to false does not affect log file removal, see also PreserveLogs setting.
diskmonitor.CdrRmFinished = 0 # remove "finished" cdrs after X days (0 = immediate)
diskmonitor.OptFileSys = # list of optional filesystems to monitor (no trimming)
diskmonitor.CoreRmDays = 1 # number of days to keep the core files
diskmonitor.CfgRmDirs = 64 # remove old config directories if more than X exist (0
= disable)
diskmonitor.logPrio = Info
diskmonitor.logFileNamePrefix = diskmonitor # causes log messages to be diverted to
diskmonitor.log
diskmonitor.TimerInterval = 60 # number of seconds before starting next task
#
# The next two parameters defines when old files should be removed.
# This task is run daily at dailyStartTime.
# Only core, log, cdr, alarm and measurements files are removed by this task.
#
diskmonitor.MaxKeepDays = 0 # maximum number of days to preserve files. use 0 to keep
forever.
diskmonitor.DailyStartTime = 04:15 # daily cleaning time (local time)
diskmonitor.PreserveLogs = false # if true and softlimit = false, log files will not be
removed even if threshold is crossed. Setting SoftLimit = true negates this setting
diskmonitor.PreserveCDRs = false # if true and softlimit = false, CDR files will not be
removed even if threshold is crossed. Setting SoftLimit = true negates this setting
#--------------------------------
# call verification utility Parameters
#--------------------------------
callver.SaveArea = ../etc/cust_specific/toolkit
#--------------------------------
# ISDNBRI
#--------------------------------
ISDNBRI.tcpPingPort = 0 # if port=0, it will disable ISDNBRI's tcp ping function.
# default value is 0.
# tcpPing will be enabled when set a valid port value,
# suggest value is 2430
#--------------------------------
# Radius Accounting Parameters
#--------------------------------
RadiusAccounting.output = off # on/off
RadiusAccounting.numberPort = 20 # The number of local port to communicate with
radius server. The range is between 10 to 99. Default value is 20.
RadiusAccounting.smSize = 30 # size of shared memory in MB. The range is between
20 to 199. Default value is 30.
#--------------------------------
# H.248
#--------------------------------
H248.maxNumH248Links = 1000
H248.maximumActionsInTransaction = 64 # Used to set maximum number of actions in one
Transaction