Filter
Top Products
5-18
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 5 Migrating to Solaris 10 and Cisco PGW 2200 Softswitch Software Release 9.8
Migration from Release 9.5 or 9.6 to Release 9.8 without Platform Changes
mml> rtrv-iplnk:all
c. Enter the following command on the standby host to verify that call replication is occurring between
the active and standby Cisco PGW 2200 Softswitch hosts:
mml> rtrv-tc:all
Step 5 Promote PGW host 2 to active:
mml> sw-over::confirm
Step 6 When the switchover is complete, verify that PGW host 2 is processing calls:
mml> rtrv-tc:all
Note If the call replication fails, or if the new Active Host is not processing calls, see the
Cisco PGW 2200 Softswitch Release 9 Operations, Maintenance, and Troubleshooting Guide.
Step 7 Complete the following steps to migrate the files to PGW host 1:
a. Log in to PGW host 1 as root.
b. Enter the following command to stop the Cisco PGW 2200 Softswitch software on PGW host 1:
# /etc/init.d/CiscoMGC stop
c. Enter the following command on PGW host 1:
# config-lib
d. At the configuration file library main menu, type 3.
The Configuration File Library Main Menu
1. List Configuration Versions in Library
2. Save Production to a new Library Version
3. Copy Library Version to Production
4. Remove Configuration Library Version
Enter Selection or 'q' to quit> 3
e. The menu lists available configuration files.
Configuration Versions
1. sip-upgrade-0131-3
2. sip-upgrade-0131
3. sip-upgrade-0131-2
4. sip-upgrade-0130
***Current Production Version = sip-upgrade-0131-3
Enter Selection to Copy or 'q' to go back>
f. Enter the number of the configuration you want to migrate.
Enter Selection to Copy or 'q' to go back> 2
***Start checking if migration is needed...
starting migration ...
Note Command output is truncated. Config-lib lists the related files as they are migrated to Release
9.8.