Filter
Top Products
A-33
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Appendix A XECfgParm.dat File Parameters
Understanding the XECfgParm.dat File Format
foverd.conn3Addr Specifies the address of the peer system.
Example: /dev/term/b
If your configuration does not use connection number 3,
enter /dev/null (default).
Note If your configuration uses an 8-port connector as a
serial connection for failover, you must modify the
read-write permissions for the connection. For more
information, see the Release Notes for the Cisco
Cisco PGW 2200 Softswitch Release 9.8.
foverd.conn3Type Sets the connection type for connection number 3.
Values:
• serial
• socket
Note Typically, set this value to serial.
foverd.delayTimeout Maximum time in milliseconds that the failover daemon can
delay at startup before sending messages to its peer. This is
also the delay offset that is added when the two failover
daemons become too closely synchronized.
Default: 1000 milliseconds (1 second)
foverd.forceShutTimeout Maximum time in milliseconds that the failover daemon
waits before forcefully shutting down the platform.
Default: 1000 milliseconds (1 second)
foverd.graceShutTimeout Maximum time in milliseconds that the failover daemon
waits before gracefully shutting down the process manager,
which shuts down the processes it controls.
Default: 6000 milliseconds (6 seconds)
foverd.heartbeatInterval Maximum time in milliseconds between heartbeat messages
from the peer failover daemon. This interval defines the
frequency that the failover daemon exchanges heartbeat
messages with its peer.
Default: 1000 milliseconds (1 second).
foverd.ipLocalPortA Port number used for IP communication.
Default: 0
Note If you have two Cisco PGW 2200 Softswitch hosts
in a failover configuration, enter this value for the
foverd.ipPeerPortA field in the XECfgParm.dat file
on the secondary host.
Table A-1 Cisco PGW 2200 Softswitch 9.x XECfgParm.dat File Configuration Parameters
Configuration Parameter Definition