Filter
Top Products
2-144
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 2 Installing the Sun Solaris 10 Operating System
Loading the Sun Solaris 10 Operating Environment
Configuring the IP Address with CLI
The SP IP address configuration with CLI on Sun Netra X4200 M2 platform is the same as the
configuration on Sun Fire X4600 platform. See Configuring the Static IP Address Using the Command
Line Interface (CLI), page 2-141.
Configuring the IP Address in BIOS
To configure the IP address for SP on the Sun Netra X4200 M2 platform, perform the following steps:
Step 1 Connect a monitor and a keyboard to the Sun box.
Step 2 Start the BIOS setup utility by following these steps:
a. Boot the system and pay attention to the prompts on the screen.
b. Press F2 to enter the BIOS setup utility when you see the prompt telling you to do so.
Step 3 Click the Advanced tab in the BIOS setup utility.
You see a screen similar to the one in Figure 2-7.
Figure 2-7 Advanced Tab in BIOS Setup Utility on Sun Netra X4200 M2 Platform
Step 4 Highlight IPMI 2.0 Configuration in the list. Then press Enter.
Step 5 Highlight LAN Configuration in the list. Then press Enter.
You see a screen similar to the one in Figure 2-8.