Filter
Top Products
2-75
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 2 Installing the Sun Solaris 10 Operating System
Loading the Sun Solaris 10 Operating Environment
Note If you used the CD-ROM drive to load the Solaris 10 patch cluster, eject the CD prior to
rebooting.
This completes the procedures for installing the Solaris 10 patches for Sparc-based platforms. Go to
Table 2-2 on page 2-72 if you want to continue with the list for package installation. If you have
questions or need assistance, see the “Obtaining Documentation and Submitting a Service Request”
section on page x.
Installing the Opteron-based Solaris 10 Patches Package (CSCOh032)
Note If you install CSCOh032 release 3.0(6) on top of release 3.0(5), run the CSCOh032 installation script
once and reboot the system. See the following installation procedure.
If you do NOT install CSCOh032 release 3.0(6) on top of release 3.0(5), you need to run the CSCOh032
installation script twice. First run the CSCOh032 installation script, then reboot the system. Then run
the CSCOh032 installation script again and reboot the system. After the second reboot is complete, use
the uname -a command to verify the patch level. If the patch level is 127128-11, CSCOh032 is
successfully installed.
To install the Opteron-based Solaris 10 Operating System Patches package (CSCOh032):
Step 1 If you are using the CD-ROM, load the Cisco Solaris 10 Operating Environment CD into the CD-ROM
drive. Enter the following command:
# pkgadd -d /cdrom/cdrom0/CSCOh032.pkg
Text similar to the following is displayed:
The following packages are available:
1 CSCOh032 Media Gateway Controller Solaris 10 Patch Cluster
(i386) 3.0(6)
Select package(s) you wish to process (or 'all' to process
all packages). (default: all) [?,??,q]:
Note You can also download the Opteron-based Solaris 10 operating system patches package
(CSCOh032) from Cisco.com. For example, download the CSCOh032 package to the /opt/SW
folder on the Opteron-based platform and use the command, pkgadd -d
/opt/SW/CSCOh032.pkg.
Step 2 Press Enter to select the default value. Text similar to the following is displayed:
Processing package instance <CSCOh032> from </var/tmp/CSCOh032.pkg>
Media Gateway Controller PGW Specific Solaris 10 packages(i386) 3.0(6)
Cisco Systems, Inc.
## Executing checkinstall script.
CSCOh032 checkinstall log file at /var/tmp/CSCOh032.checkinstall.log
Platform is i86pc
This machine is running Solaris 5.10