Filter
Top Products
2-56
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 2 Installing the Sun Solaris 10 Operating System
Loading the Sun Solaris 10 Operating System
-------------------------------------------------------------------------------
ESC-2_Continue ESC-6_Help
Note The system takes approximately 30 seconds to process this selection. A countdown appears in the
display after you activate your choice.
Step 15 Verify that No is selected and press ESC-2 to continue.
Text similar to the following is displayed:
- Set the Default Route for bge0 -----------------------------------------------
To specify the default route, you can let the software try to detect one
upon reboot, you can specify the IP address of the router, or you can choose
None. Choose None if you do not have a router on your subnet.
> To make a selection, use the arrow keys to select your choice and press
Return to mark it [X].
Default Route for bge0
--------------------------
[ ] Detect one upon reboot
[X] Specify one
[ ] None
-------------------------------------------------------------------------------
ESC-2_Continue ESC-6_Help
Step 16 Verify that Specify one is selected and press ESC-2 to continue.
Text similar to the following is displayed:
- Default Route IP Address for bge0 --------------------------------------------
Enter the IP address of the default route. This entry will be placed in the
/etc/defaultrouter file and will be the default route after you reboot
(example 129.146.89.225).
Router IP Address for bge0
-------------------------------------------------------------------------------
ESC_Continue ESC-6_Help
Step 17 Enter the Router IP address of this interface in dotted decimal format and press ESC-2 to continue.
Note See “Solaris 10 Required Media Checklist” in Table 1-2 if you used the checklist to record the
router IP address.
Text similar to the following is displayed:
- Confirm Information for bge0 -------------------------------------------------
> Confirm the following information. If it is correct, press F2;
to change any information, press F4.