Filter
Top Products
CHAPTER
2-1
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
2
Installing the Sun Solaris 10 Operating System
This chapter provides instructions for installing the packages that create the Sun Solaris 10 operating
system and its operating environment on the Sun Netra and Sun Fire platforms. The following sections
contain these instructions.
Note In the following procedures, your responses to prompts sometimes depend on the disk drive size or other
particulars of your system. These are pointed out as you follow the procedures.
• Supported Platforms, page 2-1
• Supported Disk Drives, page 2-1
• Before You Start, page 2-2
• Loading the Sun Solaris 10 Operating System, page 2-2
• Loading the Sun Solaris 10 Operating Environment, page 2-72
Note For procedures on migrating to Solaris 10 and Cisco PGW 2200 Softswitch software Release 9.8, see
Chapter 5, “Migrating to Solaris 10 and Cisco PGW 2200 Softswitch Software Release 9.8.”
Supported Platforms
This document describes the specific steps necessary for installing the Sun Solaris 10 operating system
and the operating environment on the Sun Netra and Sun Fire platforms. Two platform types are used:
Sparc-based and Opteron-based. The platforms that are supported for these products are identified in the
Cisco PGW 2200 Softswitch Hardware Installation Guide (Release 7 & 9).
Supported Disk Drives
The following disk drives are supported:
• 73 GB
• 146 GB