Filter
Top Products
5-20
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 5 Migrating to Solaris 10 and Cisco PGW 2200 Softswitch Software Release 9.8
Migration from Release 9.7 to Release 9.8 without Platform Changes
Note If the call replication fails, or if new Active Host is not processing calls, refer to the
Cisco PGW 2200 Softswitch Release 9 Operations, Maintenance, and Troubleshooting Guide.
Step 13 Restart PGW host 2 in order to ensure that the changes to the pom.dataSync variable take effect.
Migration from Release 9.7 to Release 9.8 without Platform
Changes
Perform the following procedure to migrate from Cisco PGW 2200 Softswitch Release 9.7 to
Release 9.8 without platform changes:
Step 1 Log in the Cisco PGW 2200 Softswitch as mgcusr.
Step 2 Enter the following command to stop the Cisco PGW 2200 Softswitch software:
% sudo /etc/init.d/CiscoMGC stop
Step 3 Delete the replication between the active and standby pair of the Cisco PGW 2200 Softswitches.
% ./delete_replication.sh
Step 4 Back up the .odbc.ini file manually using the following command:
% cp /opt/CiscoMGC/local/.odbc.ini /opt/CiscoMGC/etc/.odbc.ini.ttdb
Step 5 Locate the active configuration using the following commands:
% cd /opt/CiscoMGC/etc
% cd active_link
% pwd
The text similar to the following is displayed:
/opt/CiscoMGC/etc/CONFIG_LIB/CFG_Sip
Step 6 Back up the active configuration using the following commands:
% cd /opt/CiscoMGC/etc/CONFIG_LIB
% tar cvf CFG_backup973.tar ./CFG_Sip
Step 7 Back the snmp folder using the following command:
% cd /opt/CiscoMGC
% tar cvf SNMP_backup973.tar ./snmp
Step 8 Back the dial plan configurations using the following commands:
% cd /opt/CiscoMGC
% tar cvf DP_backup973.tar ./dialPlan
Step 9 Log in again as root and uninstall the Cisco PGW 2200 Softswitch software. See the “Removing a
Cisco PGW 2200 Softswitch Software Version: Sample Output for uninstall.sh” section on page E-1.