Cisco Systems PGW 2200 Switch User Manual


 
A-34
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Appendix A XECfgParm.dat File Parameters
Understanding the XECfgParm.dat File Format
foverd.ipLocalPortB Port number used for IP communication.
Default: 0
Note If you have two Cisco PGW 2200 Softswitch hosts
in a fault-tolerant configuration, enter this value for
the foverd.ipPeerPortB field in the XECfgParm.dat
file on the secondary host.
foverd.ipPeerPortA Port number used for IP communication.
Default: 0
Note If you have two Cisco PGW 2200 Softswitch hosts
in a fault-tolerant configuration, enter this value for
the foverd.ipLocalPortA field in the XECfgParm.dat
file on the secondary host.
foverd.ipPeerPortB Port number used for IP communication.
Default: 0
Note If you have two Cisco PGW 2200 Softswitch hosts
in a fault-tolerant configuration, enter this value for
the foverd.ipLocalPortB field in the XECfgParm.dat
file on the secondary host.
foverd.peerCommTimeout Maximum time in milliseconds without communication with
the remote system. At the expiration of this period, the
remote system is assumed to be unavailable and an automatic
switchover is performed.
Default: 3000 milliseconds (3 seconds)
Note A time out value that is too small can cause a false
failover, resulting in possible service interruptions.
foverd.statusRptInterval Time interval in milliseconds that governs the frequency
with which the failover daemon logs statistics on the
different connections and any failures it encountered
exchanging messages with its peer. Logs are created in the
log directory.
Default: 600000 milliseconds (10 minutes)
foverd.transitionTimeout Maximum time in milliseconds allowed for transitions
between different states of the failover daemon. This timeout
determines how long the system waits for a graceful
transition to a new state before forcing the transition. If a
timeout occurs, the system is restarted.
Default: 10000 milliseconds (10 seconds).
Table A-1 Cisco PGW 2200 Softswitch 9.x XECfgParm.dat File Configuration Parameters
Configuration Parameter Definition