Filter
Top Products
2-131
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 2 Installing the Sun Solaris 10 Operating System
Loading the Sun Solaris 10 Operating Environment
Using the SunVTS Test Package
Use the SunVTS program to test the following:
• CPUs
• Memory
• Ethernet cards
Note In order for you to fully test the Ethernet ports, all Ethernet ports must be configured with
valid IP addresses and connected to an Ethernet network with at least one other machine on
the network.
• Hard disks
• CD-ROM drive
Note In order for you to pass the DVD/CD drive test, a disk must be in the DVD/CD drive.
• LOM hardware
Normal Unit Test
The normal unit test must be successfully run on each target system before it is shipped to the customer.
A normal unit test checks 20 percent of each disk surface. To run a normal unit test, use the following
procedure.
Caution Do not run this test while the application is running because it could adversely affect the application
performance.
Step 1 Change directories to the following directory:
# cd /opt/sun_install/vts
Step 2 Enter the following command to start the test:
# ./vts_script
Text similar to the following is displayed:
You are running as root - Good...
Platform is i86pc
OS version is 5.10
Platform type is i386
VTS 64-bit binary path is /opt/SUNWvts/bin/64
OS is 64-bits
checking for VTS packages
Check to see if VTS is already installed
package SUNWvts found
package SUNWvtsr found
package SUNWvtsts found
Check to see if XML is already installed
package SUNWlxml found
VTS version: 6.4,REV=2007.07.05.10.11