Filter
Top Products
CHAPTER
1-1
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
1
Preparing for Sun Solaris Operating System and
Cisco
PGW 2200 Softswitch Software
Installation
This chapter provides checklists describing the required and optional components, software media, and
information you must have on hand before installing the Sun Solaris operating system and the
Cisco PGW 2200 Softswitch software:
• Cisco PGW 2200 Softswitch Release 9.8 and up, which requires the Sun Solaris Operating System
10
Note The entire installation procedure takes approximately 2 hours to complete.
Supported Platforms and Cisco Products
The following Cisco products are supported by this software:
• Cisco PGW 2200 Softswitch
• Cisco Billing and Measurements Server (BAMS)
• Cisco H.323 Signaling Interface (HSI)
The platforms that are supported for these products are identified in the Cisco PGW 2200 Softswitch
Hardware Installation Guide (Release 7 & 9).
Solaris 10, Cisco PGW 2200 Softswitch Software Release 9.8
and Higher Software Release Preinstallation Checklists
Table 1-1 through Table 1-4 list the required and optional tasks, information, and software media for
installing the Solaris 10 operating system and the Cisco PGW 2200 Softswitch software Release 9.8 and
higher.
Before installing the Sun Solaris operating system, Solaris patches, and alarm card software, ensure that
you collect the information and complete tasks listed in the following tables.