Filter
Top Products
3-11
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 3 Installing the Cisco PGW 2200 Softswitch Software Release 9.8 and Higher
Installing the Cisco PGW 2200 Softswitch Software Release 9.8 and Higher Releases
b. Select the specific protocol(s) you need from the tables (instead of selecting all) and enter the
protocol identifier(s).
The following prompt is displayed:
Would you like to add another protocol set to your system? [y] [y,n,?,q]
Step 11 Select one of the following options:
a. If you select y, you are prompted by the system to enter another protocol identifier (see Step 10).
b. If you select n, the system begins installing the protocols you specify, resulting in text similar to the
following for each protocol group:
Uncompressing ISUPV2_AUSTRIAN.mdo
Uncompressing ISUPV2_AUSTRIAN.so
Uncompressing ISUPV2_CZECH.mdo
Uncompressing ISUPV2_CZECH.so
Uncompressing ISUPV2_DUTCH.mdo
Uncompressing ISUPV2_DUTCH.so
Uncompressing ISUPV2_FINNISH96.mdo
Uncompressing ISUPV2_FINNISH96.so
Uncompressing ISUPV2_FRENCH.mdo
Uncompressing ISUPV2_FRENCH.so
Uncompressing ISUPV2_GERMAN.mdo
Uncompressing ISUPV2_GERMAN.so
Uncompressing ISUPV2_ISRAEL.mdo
Uncompressing ISUPV2_ISRAEL.so
Installation of <CSCO40000> was successful.
Once the all of your selected protocol groups have been installed, the system displays text similar to the
following:
Beginning Check of System Performance Requirements
Number of CPUs in system 2
Memory size: 2048 Megabytes
The sparcv9 processor operates at 1336 MHz,
Swap is total: 76384k bytes allocated + 13744k reserved = 90128k used, 5635696k available
Please Verify that you have over 4000000K Available swap
The tt60 daemon has stopped successfully.
Installation completed Wed Sep 24 03:52:32 EDT 2008
Installation log can be found in /var/adm/MGC_install.log
Note During the Cisco PGW 2200 Softswitch software installation, you may see a warning similar to
the following one in the system output:
Optimal Performance of this Software Requires 2.048 Gb of Memory!!
Ignore this warning because it is caused by an error in the install.sh script.
Step 12 Enter eject and press Enter to open the CD-ROM drive door after the installation is completed. Remove
the Cisco PGW 2200 Softswitch software CD from the tray.
Step 13 (Optional) Perform the procedure in the “Installing the Cisco Security Package (CSCOh020)” section on
page 3-12 to install the Cisco Security Package.
This completes installation of the Cisco PGW 2200 Softswitch software on a simplex host system. If you
have a fault-tolerant system, proceed to the “Installing on a Fault Tolerant System” section on page 3-17.
Otherwise, proceed to the next step.