Filter
Top Products
at a specific privilege level. If no privilege level is specified, the default is privilege
level 15.
NOTE: If you are authorized for the EXEC Privilege mode by your role, you do
not need to enter an enable password.
Related
Commands
enable password — configures a password for the enable command and to
access a privilege level.
enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
Z9500
Syntax
enable optical-info-update interval seconds
To disable optical power information updates, use the no enable optical-
info-update interval command.
Parameters
interval
seconds
Enter the keyword interval then the polling interval in
seconds. The range is from 120 to 6000 seconds. The
default is
300 seconds (5 minutes).
Defaults Disabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Replacement command for the S4820T. Replaces the
enable xfp-power-updates command.
8.3.11.4 Replacement command for the Z9000. Replaces the
enable xfp-power-updates command
8.3.10.0 Replacement command for the S4810 only. Replaces the
enable xfp-power-updates command.
Usage
Information
To enable polling and to configure the polling frequency, use this command.
Control and Monitoring
105