Filter
Top Products
• If sequence-number is not configured, the rules with the same order value are
ordered according to their configuration order.
• If sequence-number is configured, the sequence-number is used as a tie
breaker for rules with the same order.
When you use the log option, the CP processor logs detail the packets that match.
Depending on how many packets match the log entry and at what rate, the CP
may become busy as it has to log these packets’ details.
Use the monitor option only when you are using flow-based monitoring. For
more information, refer to the Port Monitoring chapter of the
Z9500 Configuration
Guide.
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default,
flow-based monitoring is not enabled.
NOTE: When ACL logging and byte counters are configured simultaneously,
byte counters may display an incorrect value. Configure packet counters with
logging instead.
Related
Commands
deny — configures a filter to drop packets.
permit — configures a filter to forward packets.
ACL VLAN Group Commands
Use the commands in this section to configure ACL VLAN groups and CAM optimization for ACLs applied
to VLAN groups.
acl-vlan-group
Create an ACL VLAN group.
Term heading Description heading
Syntax
acl-vlan-group group name
To remove an ACL VLAN group, use the no acl-vlan-group group name
command.
Parameters
group-name Enter the name of the ACL VLAN group (140 characters
maximum).
Default None
Access Control Lists (ACL)
263