Filter
Top Products
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to
drop all routes).
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
Dell Networking OS software resolves the network address the network command
configures with the routes in the main routing table to ensure that the networks are
reachable using non-BGP routes and non-default routes.
As BGP does not query next-hop information corresponding to locally originated
routes, a local route with an unreachable next-hop is chosen as the best route.
When a combination of locally originated and peer originated routes occurs, both
these routes will exist in the RTM. However, only the best route is kept active in the
RTM and the remaining route is rendered in-active.
It is possible to keep only one locally originated route in the BGP database.
Network command has preference over the re-distributed routes. When the locally
originated route is no longer present in the database the other route is
automatically installed.
In BGP, the next-hop for the route is calculated from the information that is
acquired through IGP or static routes.
Related
Commands
redistribute — redistributes routes into BGP.
Border Gateway Protocol
439