Filter
Top Products
Related
Commands
class-map — identifies the class map.
policy-aggregate
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part
of the policy map (input/output) applied on an interface.
Z9500
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate
qos-policy-name command.
Parameters
qos-policy-
name
Enter the name of the policy map in character format (32
characters maximum).
Defaults none
Command
Modes
CONFIGURATION (policy-map-input and policy-map-output)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Policy name character limit increased from 16 to 32.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage
Information
An aggregate output QoS policy applies to all outbound port traffic. An aggregate
output QoS policy can coexist with per-queue output QoS policies.
Related
Commands
policy-map-input — creates an input policy map.
policy-map-output — creates an output policy map.
1498
Quality of Service (QoS)