Filter
Top Products
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series ExaScale
(the prior limit was 2094).
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Added the access-group option.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.3.1.0 Added the count option.
Usage
Information
The following describes the debug ip packet command in the following
example.
Field Description
s= Lists the source address of the packet and the name of the
interface (in parentheses) that received the packet.
d= Lists the destination address of the packet and the name of
the interface (in parentheses) through which the packet is
being sent out on the network.
len Displays the packet’s length.
sending, rcvd,
fragment, sending
The last part of each line lists the status of the packet.
IPv4 Routing
939