Filter
Top Products
show ip bgp inconsistent-as
View routes with inconsistent originating autonomous system (AS) numbers; that is, prefixes that are
announced from the same neighbor AS but with a different AS-Path.
Z9500
Syntax
show ip bgp [ipv4 unicast] inconsistent-as
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
The following describes the show ip bgp inconsistent-as command shown
in the following example.
Field Description
Network Displays the destination network prefix of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is
listed in this column, then local routes exist in the routing
table.
Metric Displays the BGP route’s metric, if assigned.
LocPrf Displays the BGP LOCAL_PREF attribute for the route.
Weight Displays the route’s weight.
Path Lists all the ASs the route passed through to reach the
destination network.
Example
Dell>show ip bgp inconsistent-as
BGP table version is 280852, local router ID is 10.1.2.100
Status codes: s suppressed, d damped, h history, * valid, >
best
Border Gateway Protocol
467