Filter
Top Products
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Added the vlan option on the E-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Added support for the violate-action and detail
options.
6.5.1.0 Added support for Port Channel.
Example
Dell#show mac learning-limit
Interface Learning Dynamic Static Unknown SA
Slot/port Limit MAC count MAC count Drops
Te 1/0 10 0 0 0
Te 1/1 5 0 0 0
Dell#show mac learning-limit interface gig 1/0
Interface Learning Dynamic Static Unknown SA
Slot/port Limit MAC count MAC count Drops
Te 1/0 10 0 0 0
Virtual LAN (VLAN) Commands
The following commands configure and monitor virtual LANs (VLANs). VLANs are a virtual interface and
use many of the same commands as physical interfaces.
You can configure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN routing. FTP, TFTP,
ACLs and SNMP are not supported on a VLAN.
Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the VRRP state of a VLAN
interface may continually switch between Master and Backup.
NOTE: For more information, refer to VLAN Stacking and VLAN-related commands, such as
portmode hybrid in the Interfaces chapter.
Layer 2
1153