Filter
Top Products
MASK=0x00000001
OutPort
Offset: 185 Width: 7
DATA=0x00000005
MASK=0x0000007f
action={act=Drop, param0=0(0), param1=0(0),
param2=0(0), param3=0(0)}
policer=
statistics={stat id 111 slice = 2 idx=4 entries=1}
{Packets}
show hardware system-flow
Display Layer 3 ACL or QoS data for traffic flows on the central switch (aggregated CoPP) or a specified
line card and port pipe.
Z9500
Syntax
show hardware system-flow layer2 [cp-switch | linecard slot-id
port-set port-pipe]
Parameters
cp-switch Enter the keyword cp-switch to display information on
system flows of control-plane traffic.
linecard slot-id
portset port-
pipe
Enter the slot ID and port pipe to display information on
system flows on a specified Z9500 line card and port set.
The range of Z9500 slot IDs is from 0 to 2. The range of
port-pipe numbers is: 0 to 2 on line card 0; 0 to 3 on line
cards 1 and 2.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
Usage
Information
Use the show hardware system-flow command to display the system flow
entries on the central switch (aggregated CoPP) or on a specified set of Z9500
ports. The command output displays statistics on the number of hits for each
system flow.
694
Debugging and Diagnostics