Filter
Top Products
• When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that
interface.
Related
Command
vrrp delay reload — sets the delay time for VRRP initialization after a system reboot.
vrrp delay reload
Set the delay time for VRRP initialization after a system reboot.
Z9500
Syntax
vrrp delay reload seconds
Parameters
seconds Enter the number of seconds for the delay. The range is from
0 to 900 (0 indicates no delay).
Defaults 0
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage
Information
This command applies to all the VRRP configured interfaces on a system. When
used with the vrrp delay minimum CLI, the later timer rules the VRRP enabling.
For example, if
vrrp delay reload is 600 and the vrrp delay minimum is
300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up
VRRP on all interfaces that are up and configured for VRRP.
• When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that
interface.
Save the configuration and reload the system for the delay timers to take effect.
1898
Virtual Router Redundancy Protocol (VRRP)