Filter
Top Products
Usage
Information
You can configure the optimal switchover functionality for LACP even if you do not
enable the fast boot mode on the system. You must configure the long timeout
mechanism for the LACP session to enable the fast boot capability to operate
properly. This command applies to dynamic port-channel interfaces only. When
applied on a static port-channel, this command has no effect
If you configure the optimized booting-time capability and perform a reload of the
system, the LACP application sends PDUs across all the active LACP links
immediately.
Related
Commands
show lacp — displays the LACP configuration.
encapsulation dot1q
Configures lite-subinterfaces.
C9000 Series
Syntax
encapsulation dot1q vlan-id
To remove a previously configured lite-subinterface, use the no version of this
command.
Parameters
dot1q vlan-id Enter the keyword dot1q followed by the VLAN ID to which
the host belongs. The range is from 1 to 4094. A lite
subinterface is considered as a Layer 3 port property and is
synchronous with the existing rules of applying Layer 2 or
Layer 3 properties to an interface.
Command
Modes
INTERFACE
Command
History
Version Description
9.x.x.x Introduced on the C9000.
9.3.0.0 Introduced on the S6000.
Usage
Information
To enable routing of RRoCE packets, the VLAN ID is mapped to the default VLAN ID
of 4095 and this mapping is performed using VLAN translation. After VLAN
translation, the RRoCE packets are considered in the same manner as normal IP
packets that received on L3 interface and routed in the egress direction. At the
egress interface, the VLAN ID is appended to the packet and transmitted out of the
interface as a tagged packet with the dot1Q value preserved. The dot1Q value is
preserved only for egress interfaces that are associated with a VLAN or a lite-
Flex Hash
755