Filter
Top Products
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
access_list_na
me
Enter the name of the access list.
Defaults Default SSM range is 232/8 and ff3x/32
Command
Modes
CONFIGURATION
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON. Added support for VRF on
S6000, S4810, S4820T, Z9000, Z9500, and S6000–ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
Usage
Information
Dell Networking OS supports standard access lists for the SSM range. You cannot
use extended ACLs for configuring the SSM range. If you configure an extended
ACL and then used in the ip pim ssm-range {access list name}
configuration, an error is reported.
However, if you configure ip pim ssm-range {access list name} first and
then you configure the ACL as an Extended ACL, an error is not reported and the
ACL is not applied to the SSM range.
Dell Networking OS-recommended best-practices are to configure the standard
ACL, and then apply the ACL to the SSM range. After the SSM range is applied, the
changes are applied internally without requiring clearing of the tree information
base (TIB).
When the ACL rules change, the ACL and protocol-independent multicast (PIM)
modules apply the new rules automatically.
When you configure the SSM range, Dell Networking OS supports SSM for
configured group range as well as the default SSM range.
PIM-Source Specific Mode (PIM-SSM)
1419