Filter
Top Products
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S4820T, S4810, S6000, S5000, Z9000,
S6000–ON and Z9500.
Parameter
Enter the value (in seconds) to specify the time interval for delay restore timer to
abort. This timer is applicable only during reload/boot-up and not in other
scenarios (example, ICL flap).
The range is from 1 to 1800 seconds.
Usage
Information
To abort VLT delay restore timer as the maximum threshold, the maximum time
interval is applied to hold down ICL peer-up in the start-up configurations during
the reload.
lacp ungroup member-independent
Prevent possible loop during the bootup of a VLT peer switch or a device that accesses the VLT domain.
Syntax
lacp ungroup member-independent {vlt | port-channel}
Parameters
port-channel Force all LACP port-channel members to become
switchports.
vlt Force all VLT LACP members to become switchports.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
1854
Virtual Link Trunking (VLT)