Filter
Top Products
scp: file-url Enter the keyword scp: and specify the location of the
image file in the format userid:password@host-ip/
filepath or press Enter to launch a prompt sequence.
tftp: file-url Enter the keyword tftp: and specify the location of the
image file in the format
//host-ip/filepath or press
Enter to launch a prompt sequence.
flash: file-url Enter the keyword flash: and specify the location of the
image file in the format //directory-path or press Enter
to launch a prompt sequence.
usbflash: file-
url
Enter the keyword usbflash: and specify the location of
the source file in the format //directory-path to upgrade
form an external flash device or press Enter to launch a
prompt sequence.
A: | B: Specify the flash partition of the operating-system image to
be upgraded.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.0(0.0) Added support for IPv6 for the file-url parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000. Added support for the SSD on the
Z9000 only.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added support for TFTP and SCP.
7.6.1.0 Introduced on the S-Series.
Usage
Information
RFC 3986 specifies that IPv6 host addresses in a uniform resource identifier (URI)
must be enclosed in square brackets, [X:X:X:X::X]. For maximum flexibility this
command accepts IPv6 host addresses with or without the square brackets.
After you upgrade the system image, by entering the command. specify the
location where the Dell Networking OS image used to boot the system is stored
(boot system), save the configuration to the start-up config file (write memory),
and reload the system (reload).
84
File Management