Filter
Top Products
Defaults Off
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.1(0.0) Added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced.
Usage
Information
When you enable soft-reconfiguration for a neighbor and you execute the clear
ip bgp soft in
command, the update database stored in the router is replayed
and updates are re-evaluated. With this command, the replay and update process is
triggered only if route-refresh request is not negotiated with the peer. If the
request is indeed negotiated (after executing the clear ip bgp soft in
command), BGP sends a route-refresh request to the neighbor and receives all of
the peer’s updates.
Related
Commands
clear ip bgp — activates inbound policies without resetting the BGP TCP session.
capture bgp-pdu neighbor
Enable capture of an IPv4 BGP neighbor packet.
Z9500
Syntax
capture bgp-pdu neighbor ipv4-address direction {both | rx |
tx}
To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-
pdu neighbor ipv4-address command.
Parameters
ipv4-address Enter the IPv4 address of the target BGP neighbor.
386
Border Gateway Protocol