Filter
Top Products
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show ip route summary shown in the following
example.
Column Heading Description
Route Source Identifies how the route is configured in the system.
Active Routes Identifies the best route if a route is learned from two
protocol sources.
Non-active
Routes
Identifies the back-up routes when a route is learned by two
different protocols. If the best route or active route goes
down, the non-active route becomes the best route.
ospf 100 If routing protocols (OSPF, RIP) are configured and routes
are advertised, then information on those routes is
displayed.
Total 1388
active...
Displays the number of active and non-active routes and
the memory usage of those routes. If there are no routes
configured in the system, this line does not appear.
Example
Dell>show ip route summary
Route Source Active Routes Non-active Routes
connected 17 0
static 3 0
ospf 100 1368 2
Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
Total 1388 2
Total 1388 active route(s) using 222440 bytes
IPv4 Routing
983