Filter
Top Products
Version Description
8.3.12.0 Introduced on the S4810.
7.4.1.0 Introduced on the S6000.
Usage
Information
The router with the largest value assigned to an interface becomes the designated
router. If two interfaces contain the same designated router priority value, the
interface with the largest interface IP address becomes the designated router.
ipv6 pim join-filter
Permit or deny PIM Join/Prune messages on an interface using an access list. This command prevents the
PIM-SM router from creating state based on multicast source and/or group.
Syntax
ipv6 pim join-filter access-list
Parameters
access-list Enter the name of an extended access list.
in Enter the keyword in to apply the access list to inbound
traffic.
out Enter the keyword out to apply the access list to outbound
traffic.
Defaults none
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
7.3.1.0 Introduced on the S6000.
Example
Dell(conf)#ipv6 access-list JOIN-FIL_ACL
Dell(conf-ipv6-acl)#permit ipv6 165:87:34::0/112 ff0e::
225:1:2:0/112
Dell(conf-ipv6-acl)#permit ipv6 any ff0e::230:1:2:0/112
Dell(conf-ipv6-acl)#permit ipv6 165:87:32::0/112 any
Dell(conf-ipv6-acl)#exit
Dell(conf)#interface tengigabitethernet 1/1
PIM-Sparse Mode (PIM-SM)
1407