Filter
Top Products
Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced to all platforms.
Usage
Information
This command is either enabled or disabled. If no OSPF process is identified as the
MIB manager, the first OSPF process is used.
If an OSPF process has been selected, it must be disabled prior to assigning new
process ID the MIB responsibility.
network area
Define which interfaces run OSPF and the OSPF area for those interfaces.
Z9500
Syntax
network ip-address mask area area-id
To disable an OSPF area, use the no network ip-address mask area area-
id
command.
Parameters
ip-address Specify a primary or secondary address in dotted decimal
format. The primary address is required before adding the
secondary address.
mask Enter a network mask in /prefix format. (/x)
area-id Enter the OSPF area ID as either a decimal value or in a valid
IP address. Decimal value range is from 0 to 65535. IP
address format is dotted decimal format A.B.C.D.
NOTE: If the area ID is smaller than 65535, it is converted
to a decimal value. For example, if you use an area ID of
0.0.0.1, it is converted to 1.
Command
Modes
ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
Open Shortest Path First (OSPFv2 and OSPFv3)
1287