Filter
Top Products
Defaults In IS-IS, the default deletes LSPs with internal checksum errors (no ignore-lsp-
errors).
Command
Modes
ROUTER ISIS
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage
Information
IS-IS normally purges LSPs with an incorrect data link checksum causing the LSP
source to regenerate the message. A cycle of purging and regenerating LSPs can
occur when a network link continues to deliver accurate LSPs even though there is
a link causing data corruption. This process could cause disruption to your system
operation.
ip router isis
Configure IS-IS routing processes on an interface and attach an area tag name to the routing process.
Z9500
Syntax
ip router isis [tag]
To disable IS-IS on an interface, use the no ip router isis [tag] command.
Parameters
tag (OPTIONAL) The tag you specify identifies a specific area
routing process. If you do not specify a tag, a null tag is
assigned.
Defaults No processes are configured.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
1082
Intermediate System to Intermediate System (IS-IS)