Filter
Top Products
Version Description
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
This command provides egress port information for a given IP flow. This
information is useful in identifying which interface the packet follows in the case of
Port-channel and Equal Cost Multi Paths. Use this command for routed packed
only. For switched packets, use the show port-channel-flow command.
The show ip flow command does not compute the egress port information
when load-balance mac hashing is also configured due to insufficient
information (the egress MAC is not available).
S-Series produces the following error message: %Error: Unable to read IP
route table
.
Example
Dell#show ip flow interface Te 1/8 189.1.1.1 63.0.0.1 protocol
tcp source-port 7898 destination-port 8
flow: 189.1.1.1 63.0.0.1 protocol 6 7868 8976
Ingress interface:Te 1/20
Egress interface:Te 1/14 to 1.7.1.2[CAM hit 103710]
unfragmented packet
Te 1/10 to 1.2.1.2[CAM hit 103710] fragmented
packet
show ip interface
View IP-related information on all interfaces.
Z9500
Syntax
show ip interface [interface | brief] [configured]
Parameters
interface (OPTIONAL)
Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
IPv4 Routing
973