Filter
Top Products
Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series for the port-channels and the S-
Series.
Usage
Information
The interface must be enabled (the no shutdown command) and not have the
switchport command configured. Multicast must also be enabled globally (using
the
ip multicast-lag-hashing command). PIM is supported on the port-
channel interface.
ip pim sparse-mode sg-expiry-timer
Enable expiry timers globally for all sources.
Z9500
Syntax
ip pim [vrf vrf-name] sparse-mode sg-expiry-timer seconds
To disable configured timers and return to default mode, use the no ip pim
[vrf vrf-name] sparse-mode sg-expiry-timer command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to enable expiry timer for all sources on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
seconds Enter the number of seconds the S, G entries are retained.
The range is from 211 to 65535.
Defaults Disabled. The default expiry timer (with no times configured) is 210 sec.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Removed the acl-access-list parameter. Modified the max
value of S, G entry second range from 86400 to 65535.
Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
PIM-Sparse Mode (PIM-SM)
1387