Filter
Top Products
Example Dell(conf)# util-threshold memory cp high 75 low 67
Usage
Information
When the total memory utilization for a CPU exceeds the configured high/low
threshold for a given time, a threshold notification is sent as a SNMP trap. If a low
threshold value is not specified, the low threshold value is set to the same value as
the high threshold value.
To return the memory thresholds to the default values, enter the no util-
threshold mem cp | rp | linecard
slot—id | all command.
Related
Commands
show util-threshold memory – Display the configured values of memory utilization
thresholds.
show util-threshold cpu – Display the configured values of CPU utilization
thresholds.
virtual-ip
Configure a virtual IP address for the active management interface. You can configure virtual addresses
both for IPv4 and IPv6 independently.
Z9500
Syntax
virtual-ip {ipv4-address | ipv6-address}
To return to the default, use the no virtual-ip {ipv4-address | ipv6-
address
} command.
Parameters
ipv4-address Enter the IP address of the active management interface in a
dotted decimal format (A.B.C.D.).
ipv6-address Enter an IPv6 address of the active management interface, in
the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Control and Monitoring
189