Filter
Top Products
Parameters
prefix-list-
name
Enter the name of the configured prefix list, up to 140
characters long.
StartingSeqNu
m
Enter the starting sequence number to resequence. The
range is from 0 to 65535.
Step-to-
Increment
Enter the step to increment the sequence number. The
range is from 1 to 65535.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage
Information
When you have exhausted all the sequence numbers, this feature permits re-
assigning a new sequence number to entries of an existing prefix list.
Related
Commands
resequence access-list — resequences an access-list.
seq
Assign a sequence number to a deny or permit filter in an IP access list while creating the filter.
Z9500
Syntax
seq sequence-number {deny | permit} {source [mask] | any | host
ip-address}} [count [bytes]] [dscp value] [order] [fragments]
[log [interval minutes] [threshold-in-msgs [count]] [monitor]
To delete a filter, use the no seq sequence-number command.
230
Access Control Lists (ACL)