Filter
Top Products
show interfaces — displays the negotiated flow control parameters.
interface
Configure a physical interface on the switch.
Z9500
Syntax
interface interface range
Parameters
interface Enter one of the following keywords and slot/port or number
information:
• For a null interface, enter the keyword null then the
slot/port information. The Null interface number is 0.
• For a Management Ethernet interface, enter the keyword
managementethernet then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then the slot/port information. The range is from 0 to
16383.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Tunnel interface, enter the keyword tunnel then
the tunnel ID. The range is from 1 to 16383.
• For a VLAN interface, enter the keyword vlan then the
slot/port information. The range is from 1 to 4094.
range (Optional) Enter the keyword range to configure an
interface range.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
842
Interfaces