Filter
Top Products
Usage
Information
Save the new CAM settings to the startup-config (write-mem or copy run
start) then reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three
blocks; these blocks cannot be reallocated. The ipv4acl profile range is from 1 to
4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which
is from 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If allocation values are not entered for the CAM regions, the value is 0.
If you enable BMP 3.0, to perform a reload on the chassis to upgrade any
configuration changes that have changed the NVRAM content, use the command
reload conditional nvram-cfg-change.
cam-audit linecard
Enable audit of the IPv4 forwarding table on all line cards.
Z9500
Syntax
cam-audit linecard all ipv4-fib interval time-in-minutes
Parameters
all Enter the keyword all to enable CAM audit on all line cards.
ipv4-fib Enter the keyword ipv4-fib to designate the CAM audit on
the IPv4 forwarding entries.
interval time-
in-minutes
Enter the keyword interval followed by the frequency in
minutes of the CAM audit. Range: 5 to 1440 minutes (24
hours). Default:
60 minutes.
Defaults Disabled
Command
Modes
CONFIGURATION
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
7.4.1.0 Introduced on the E-Series.
96
Control and Monitoring