Filter
Top Products
show ip bgp cluster-list — views paths with a cluster ID.
bgp confederation identifier
Configure an identifier for a BGP confederation.
Z9500
Syntax
bgp confederation identifier as-number
To delete a BGP confederation identifier, use the no bgp confederation
identifier as-number command.
Parameters
as-number Enter the AS number. The range is from 0 to 65535 (2 byte),
from 1 to 4294967295 (4 byte), or from 0.1 to 65535.65535
(dotted format).
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series. Added support for the 4-byte
format
Usage
Information
To accept 4-byte formats before entering a 4-byte AS number, configure your
system. All the routers in the Confederation must be 4 byte or 2 byte identified
routers. You cannot mix them.
The autonomous systems configured in this command are visible to the EBGP
neighbors. Each autonomous system is fully meshed and contains a few
connections to other autonomous systems. The next hop, MED, and local
preference information is preserved throughout the confederation.
372
Border Gateway Protocol