Filter
Top Products
Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series for the port-channels and the S-
Series.
7.7.1.1 Introduced
Usage
Information
This command configures an expiration timer for all S.G entries, unless they are
assigned to an Extended ACL.
Even though the FHR nodes act as RPs, these nodes still send Register encap
messages to themselves and expect to receive a Register stop message (for
Anycast RP support). As a result, if the DLT timer expires, SG is not deleted until the
register state is deleted in the node. This register state expires 210 seconds after
the last Null register is received.
ip pim spt-threshold
To switch to the shortest path tree when the traffic reaches the specified threshold value, configure the
PIM router.
Z9500
Syntax
ip pim [vrf vrf-name] spt-threshold [infinity]
To return to the default value, use the no ip pim [vrf vrf-name] spt-
threshold [infinity] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to configure the PIM router on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
infinity (OPTIONAL) Enter the keyword infinity to never switch to
the source-tree.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
1388
PIM-Sparse Mode (PIM-SM)