Filter
Top Products
Usage
Information
This command allows you to monitor adjacency state changes, which are useful
when you monitor large networks. Messages are logged in the system’s error
message facility.
lsp-gen-interval
Set the minimum interval between successive generations of link-state packets (LSPs).
Z9500
Syntax
lsp-gen-interval [level-l | level-2] interval seconds
[initial_wait_interval seconds [second_wait_interval seconds]]
To restore default values, use the no lsp-gen-interval [level-l |
level-2] interval seconds [initial_wait_interval seconds
[second_wait_interval seconds]] command.
Parameters
level-l (OPTIONAL) Enter the keywords level-1 to apply the
configuration to generation of Level-1 LSPs.
level-2 (OPTIONAL) Enter the keywords level-2 to apply the
configuration to generation of Level-2 LSPs.
interval
seconds
Enter the maximum number of seconds between LSP
generations. The range is from 0 to 120 seconds. The default
is 5 seconds.
initial_wait_inte
rval seconds
(OPTIONAL) Enter the initial wait time, in seconds, before
running the first LSP generation. The range is from 0 to 120
seconds. The default is 1 second.
second_wait_i
nterval seconds
(OPTIONAL) Enter the wait interval, in seconds, between the
first and second LSP generation. The range is from 0 to 120
seconds. The default is 5 seconds.
Defaults Refer to Parameters.
Command
Modes
ROUTER ISIS
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
1096
Intermediate System to Intermediate System (IS-IS)