Filter
Top Products
To remove the input policy map from the interface, use the no service-policy
input policy-map-name [layer2] command.
Parameters
policy-map-
name
Enter the name for the policy map in character format (32
characters maximum). You can identify an existing policy
map or name one that does not yet exist.
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2
Class Map. The default is Layer 3.
Defaults Layer 3
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 E-Series Only: Expanded to add support for Layer 2.
6.1.1.1 Introduced on the E-Series.
Usage
Information
You can attach a single policy-map to one or more interfaces to specify the
service-policy for those interfaces. A policy map attached to an interface can be
modified.
NOTE: The service-policy commands are not allowed on a port channel.
The
service-policy input policy-map-name command and the
service-class dynamic dot1p command are not allowed simultaneously
on an interface. However, the service-policy input command (without
the
policy-map-name option) and the service-class dynamic dot1p
command are allowed on an interface.
Related
Commands
policy-map-input — creates an input policy map.
1506
Quality of Service (QoS)