Filter
Top Products
switchport
no shutdown
Dell(conf-if-range-te-1/1-2)#
show interfaces
Display information on a specific physical interface or virtual interface, or the interfaces of the same type
on a line card.
Z9500
Syntax
show interfaces [interface] [linecard slot-id]
Parameters
interface Enter one of the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel then
the tunnel ID. The range is from 1 to 16383.
linecard slot-id Enter the linecard slot-id parameters to specify the
Z9500 ports on a line card. The range of slot IDs is from 0 to
2.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Added support for the tunnel interface type.
866
Interfaces