Filter
Top Products
Defaults Granularity for commited-rate and peak-rate is Mbps unless you use the kbps
option.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-
Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage
Information
NOTE: Per Port rate limit and rate police is supported for Layer 2 tagged and
untagged switched traffic and for Layer 3 traffic. Per VLAN rate limit and rate
police is supported on only tagged ports with Layer 2 switched traffic.
On one interface, you can configure the rate police command for a VLAN or
you can configure the rate police command for an interface. For each physical
interface, you can configure three
rate police commands specifying different
VLANS.
Related
Commands
rate-police — specifies traffic policing on the selected interface.
rate shape
Shape the traffic output on the selected interface.
Z9500
Syntax
rate shape [kbps] rate [burst-KB]
Parameters
kbps (Optional) Enter the keyword kbps to specify the rate limit in
kilobits per second (Kbps). The range is from 0 to 10000000.
The default granularity is Megabits per second (Mbps).
1484
Quality of Service (QoS)