Filter
Top Products
soft (OPTIONAL) Enter the keyword soft to configure and
activate policies without resetting the BGP TCP session, that
is, BGP Soft Reconfiguration.
NOTE: If you enter the clear ip bgp ip-address
soft
command, both inbound and outbound policies
are reset.
in (OPTIONAL) Enter the keyword in to activate only inbound
policies.
out (OPTIONAL) Enter the keyword out to activate only
outbound policies.
NOTE: You must execute the clear ip bgp soft
out command when ever there is a change in the local
policy. If you do not run this command after a local
policy change, then these policy changes are not
reflected in the responses to the peer’s route refresh
messages.
dampening Enter the keyword dampening to clear the flap dampening
information.
flap-statistics Enter the keywords flap-statistics to clear the flap
statistics information.
ipv4 Enter the ipv4 address family to clear.
ipv6 Enter the ipv6 address family to clear.
peer-group Enter the peer-group to clear all members of the peer-
group.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
6.5.1.0 Expanded to include the as-number option.
Border Gateway Protocol
389