Filter
Top Products
Defaults non-hybrid
Command
Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
The following describes the interface command shown in the following
example. This example sets a port as hybrid, makes the port a tagged member of
VLAN 20, and an untagged member of VLAN 10, which becomes the native VLAN
of the port. The port now accepts:
• untagged frames and classify them as VLAN 10 frames
• VLAN 20 tagged frames
The following describes the do show interfaces command shown in the
following example. This example shows output with “Hybrid” as the newly added
value for 802.1QTagged. The options for this field are:
• True — port is tagged
• False — port is untagged
• Hybrid — port accepts both tagged and untagged frames
The following describes the interface vlan command shown in the following
example. This example shows unconfiguration of the hybrid port using the no
portmode hybrid
command.
NOTE: Remove all other configurations on the port before you can remove
the hybrid configuration from the port.
Example
Dell(conf)#interface te 2/0
Dell(conf-if-te-2/0)#portmode hybrid
Dell(conf-if-te-2/0)#interface vlan 10
Dell(conf-if-vl-10)#untagged te 2/0
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#tagged te 2/0
Dell(conf-if-vl-20)#
Interfaces
861