Filter
Top Products
Parameters
half Enter the keyword half to set the Management interface to
transmit only in one direction.
full Enter the keyword full to set the Management interface to
transmit in both directions.
Defaults Not configured.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Documentation modified—added Management to
distinguish from duplex (10/100 Interfaces).
Usage
Information
This command applies only to the Management interface on the route processor
modules (RPMs).
Related
Commands
interface ManagementEthernet — configures the Management port on the system
(either the Primary or Standby RPM).
duplex (Management) — sets the mode of the Management interface.
management route — configures a static route that points to the Management
interface or a forwarding router.
speed (Management interface) — sets the speed on the Management interface.
flowcontrol
Enable and disable link-level flow control (802.3x pause frames) on an interface and (optionally)
configure buffer thresholds for pause and offset frame transmission.
Z9500
Syntax
flowcontrol rx {off | on} tx {off | on} [pause-threshold
{1-12480}] [resume-offset {1-12480}]
Interfaces
839